Hazard statements

H290 May be corrosive to metals.
H314 Causes severe skin burns and eye damage.
H335 May cause respiratory irritation.

DANGER

Remove any coatings beforehand using Finalit No. 5 Coating Remover!
Moisten the surfaces with water before working and, where possible, apply from the bottom to the top!

• Can be diluted up to 1:20 with water depending on the degree of soiling   
• 1 litre is sufficient for 80 m² 
• Attention! Roughen up closed layers of lime with a coarse brush or sandpaper 
• Generously apply the lime solvent to the surface to be cleaned and allow to act for 5–10 minutes 
• Brush off with a rough brush or sponge 
• Then thoroughly rinse with water 
• Apply Finalit No.1 diluted 1:20 with water for neutralising 
• Allow to act for about 5 - 10 minutes 
• Then wash off the entire surface well with water 
• If necessary, repeat the application and increase the exposure time 
• Take care with metals: cover them up!

Suitable for all natural and artificial stones, except polished soft stone!

Not suitable for polished softstone (e.g. marble, limestone)!
You need to make your own tests.

• Extremely powerful lime remover (where possible, with lime layers that are very thick, burn away any lime flags layer for layer using a flame or Bunsen burner. Water in lime boils, thus exploding the lime; wear protective goggles. Important: Roughen-up the remaining layer of lime with a copper brush in order to allow No. 6 to take effect!)
• Crystal water stain remover (together with No. 8 Rust Solvent (1:1), moisten the surface first and allow to act overnight. A yellow film forms, that should be removed and neutralised using No. 1 (1:20).
• Lime on polished soft stone, remove using a ceramic brush grain 1000, dry, level 1 hand machine