Finalit No. 6 Lime Solvent (acidic)

  • Removes outer layers of lime. 
  • Crystal water stain remover. 
  • Intensive basic cleaner for lime, salt and gypsum efflorescence. 

Can be diluted up to 1:20 with water depending on the degree of soiling. 1 litre is sufficient for 80 m².

ATTENTION! Remove any coatings beforehand using Finalit No. 5 Coating Remover!
Moisten the surfaces with water before working and, where possible, apply from the bottom to the top!


Application areas:

  • Extremely powerful lime remover 
  • Crystal water stain remover 
  • Intensive basic cleaner for lime, salt and gypsum efflorescence

Suitable for all natural and artificial stones, except polished soft stone!

ATTENTION! Not suitable for polished softstone (e.g. marble, limestone)!
You need to make your own tests.

  • Can be diluted up to 1:20 with water depending on the degree of soiling   
  • 1 litre is sufficient for 80 m² 
  • Attention! Roughen up closed layers of lime with a coarse brush or sandpaper 
  • Generously apply the lime solvent to the surface to be cleaned and allow to act for 5–10 minutes 
  • Brush off with a rough brush or sponge 
  • Then thoroughly rinse with water 
  • Apply Finalit No.1 diluted 1:20 with water for neutralising 
  • Allow to act for about 5 - 10 minutes 
  • Then wash off the entire surface well with water 
  • If necessary, repeat the application and increase the exposure time 
  • Take care with metals: cover them up!
 

Suitable for all natural and artificial stones, except polished soft stone!

ATTENTION! Not suitable for polished softstone (e.g. marble, limestone)!
You need to make your own tests.

  • Extremely powerful lime remover (where possible, with lime layers that are very thick, burn away any lime flags layer for layer using a flame or Bunsen burner. Water in lime boils, thus exploding the lime; wear protective goggles. Important: Roughen-up the remaining layer of lime with a copper brush in order to allow No. 6 to take effect!)
  • Crystal water stain remover (together with No. 8 Rust Solvent (1:1), moisten the surface first and allow to act overnight. A yellow film forms, that should be removed and neutralised using No. 1 (1:20).
  • Lime on polished soft stone, remove using a ceramic brush grain 1000, dry, level 1 hand machine